LEDdriver16Leddriver16 front

LEDdriver16 is a DMX512 steered 16-fold dimmer pack for flicker free dimming of led-panels, led-downlights, led-strips etc. This device (plus a DC-voltage supply) replaces the more or less dimmable common drivers/adapters, needed to connect led light sources on mains.

LEDdriver16 gives you the possibility to dim led light sources like led-panels, led-downlights etc. with the same quality as is possible for standard halogen lamps by use of a triacdimmer. With LEDdriver16 you get an absolute flicker free led lighting. It is the best choice for TV-studios, film-studios, film halls, theater halls etc. The lighting system is buildup by one or more LEDdriver16 an equal amount DC-power supplies, DMX-controller and the led light sources.

You can supply the LEDdriver16 by one or two power supplies. In case you use one power supply you can only connect led light sources with the same nominal working voltage. In case you use two power supplies with different output voltage you can connect group wise two different types of light sources with the same nominal working voltage: one type on output 1-8 and the other type on output 9-16. The output voltage of the DC-power supply must match with this led voltage. For example led down-lights working on 32V need a power supply of about 36V. For the highest efficiency you have to adjust the output voltage of the power supply to the lowest value at which you get the maximum luminous efficiency of the LED-light.

LEDdriver16 controls the light intensity of the connected led light source by controlling the current flowing through the leds from zero up till a certain value at which the maximum light intensity will be produced.

Features:

  • 16 channels dmx controlled current source for absolute flicker free dimming of LED lights 
  • For each channel the maximum output current can be set from 0,1[A ] up till 3,6[A.] To get a higher drive capacity it is possible to connect two or more outputs in parallel.
  • For each channel nine different control curves can be set: non-dim, linear and zeven LED light curves
  • You can use one or two power supplies in the range of 12V,....,60V.  If you use two power supplies they may have different output  voltage.
  • 3-digit led display for setting and displaying the DMX address
  • DMX512 input galvanic isolated, fail save for open input and protected against over voltage. 
  • Led indication for DMX512 present
  • Hold of DMX-data by lost of signal can be set on or off
  • All components are PCB mounted (no internal wiring)
  • Very compact design suitable for 19-inch racks , together with the 19inch brackets-set
Specifications:
  • Power supply inlet: 4-pole male WAGO connector (42[A]); LEDdriver16 comes with a 4-pole female WAGO connector to connect the power supply.
  • The output is on four times an 8-pole female WAGO connectors; LEDdriver16 will be delivered inclusive four 8-pole WAGO male connectors
  • DMX-input: 5 pole XLR male, NEUTRIK, PCB- mounted 
  • DMX-through: 5- pole XLR  female, NEUTRIK, PCB- mounted 
References:
  • Lichtmacht - Studio Goede tijden slechte tijden, Utopia
  • Theater De Lieve Vrouw, Amersfoort - Foyer
  • Controllux - Congres Centrum Utrecht
  • Toneelgroep Amsterdam - The Fountainhead premiere Seoel 30-3-2017
Dimensions:
  • 416 x 140 x 47[mm]
  • Weight: 1,95 [kg]
Manual: Acessoires:
  • MEAN-WELL switched mode power supply
  • Two wall straps for wall mounting purposes
  • 19inch brackets-set 
Leddriver16 back